一是減少裝載機沖擊和振動，使用減振支架固定所有管子，適當布置壓力控制閥以保護系統的所有元件，盡量減少管接頭的使用數量并盡量采用焊接，使用直螺紋接頭、三通接頭和彎頭代替錐管螺紋接頭。
One is to reduce the impact and vibration of Shandong loader, using damping bracket fixed all the pipes of all components appropriately arranged pressure control valve to protect the system, try to reduce the number of joint use and adopt welding, using straight thread joints, three joints and elbow instead of tapered pipe thread.

二是減少裝載機動密封件的磨損，消除活塞桿和驅動軸密封件上的側載荷；用防風圈、防護罩和橡膠套保護活塞桿，防止磨料、粉塵等雜質侵入。
The two is to reduce the loading of the Shandong motor seal wear, eliminate the piston rod and drive shaft seal on the side load; with the wind ring, protective cover and rubber sleeve to protect the piston rod, prevent abrasive, dust and other impurities intrusion.

三是控制裝載機油溫，防止密封件變質，溫度每升高10℃，密封件使用壽命就會減半。應該根據設備的實際使用情況設置冷卻裝置，使油液溫度保持在65℃以下。使用的油液與密封材料要相適應，以延長密封件的使用壽命。
The three is to control the Shandong loader oil seal, to prevent deterioration, increasing the temperature of 10 DEG C, the service life of the sealing element will be halved. The cooling device should be set according to the actual use of the equipment to keep the oil temperature below 65 degrees celsius. The use of oil and sealing materials to adapt to extend the service life of seals.